Will the throttle valve be damaged by frequent cleaning? Should it be removed or washed on the car?

The number of times the throttle valve is cleaned has a greater impact on the development of my car habit and the cyberspace. Most cars can be cleaned after 20,000 kilometers, and very few cars will be cleaned after more than 10,000 kilometers. Nowadays, many cars in China are all Chinese electronic throttle valves, which are particularly sensitive to the reaction speed of carbon deposits. If there is too much carbon deposition, abnormal analysis will occur immediately, which is specifically manifested in scientific research. For example, idling jitter, throttle jitter, speeding up side effects, slow working ability, not easy to ignite, etc. , and even some cars illuminate the fault indicator immediately, so they have carbon deposits, and common fault management methods continue to occur, and they have to be cleaned as a last resort. Some people say that you don’t have to wash the throttle valve because it has to be washed so often. Is that really the only one? Today, let’s talk about the issue of data and information cleaning the throttle.
Being able to wash the throttle is not an arbitrary issue, but a real one. But it wasn’t bad then. It will take a while. Once the festival gate valve is broken, it needs to be replaced, and the community owner has just cleaned it recently, which is probably related to cleaning, so cleaning is possible. However, only a very small number of throttles are broken, and most of them are not easy to break. The primary factor for cleaning is unreasonable use and aging of the throttle.
How bad is this? It is the infiltration of the internal structure of the throttle body in the cleaning agent, which is caused by the erosion of the circuit board. The closing and closing operation of the throttle opening is a baffle, and the baffle has a shaft that opens to the throttle body. The shaft and the touching part of the throttle body are the most easily dirty, and cleaning is the most difficult. So a lot of people here use a soap powder sprayer, spray a lot of detergent, and then a towel. Water permeability is a better throttle cleaning agent, the sprayer is more likely to pass through the shaft double slit, and the internal structure of the throttle body wear-resistant components will cause all the throttle damage. In addition, if the hard block exceeds the carbon of the screwdriver, the throttle valve is very easy to scratch, causing the throttle valve to be damaged. The most common is the two actual operations, resulting in poor throttle.
When cleaning the throttle, it is best to spray the cleaner on a towel, break the throttle baffle, and then scrub with the towel. Maintenance must also be taken care of. If you can’t clean it once, you should scrub it multiple times. You can also spray the cleaner on the throttle valve at the same time, but it should be noted that everyone try not to spray too much at the root of the drive shaft, a small amount of cleaner is not harmful. As everyone knows, the throttle valve is bad. In fact, the aging of China and the company itself has greater harm. The new throttle valve seals well. Even if a lot of cleaning agents are sprayed, it is difficult to properly penetrate the trainees. As there are many key components of plastic on the car, if used properly, it will be broken in one disassembly. In addition, teachers need to pay attention to the selection of cleaning agents. It’s best to apply some unique throttle cleaner. Other social development and corrosive cleaning agents should not be used, which will corrode the throttle valve.
Therefore, with proper cleaning agent and correct operation steps, the throttle valve is not easy to be cleaned, and the actual operation may be abnormal. Finally, let’s talk about cleaning or should cleaning be deleted? Disassembly and cleanup are much easier to operate and clean up. If you wash it yourself, determine how dirty the throttle is and how diverse the throttle is. If the throttle is very easy to remove, then move to clean up. If the part is not very good, it is not easy to remove, and it is not particularly dirty, it is in the car wash. If it is spent on cleaning in the maintenance shop, it is best to remove it and wash it, so that it will be cleaned.


Post time: Feb-19-2022